WODE Unbricking Hardware
WODE PROGRAMMER DFU KIT - NXP LPC3143 FAMILY
- The WODE Programmer DFU Kit is believed to be the first device created by the WODE Team to aid sellers in the recovery of wodes that have a corrupted boot. With this programmer you can re-program and "unbrick" none working wodes, The device is also capable of showing the user the cause of issue of the Main Board, like RAM issue, FLASH issue etc..
WODE Unbrick software is a collection of tools put together by the WODE Team to aid sellers in the recovery of wode's that have a corrupted boot
- Known causes of corrupted boots/ wode's range from if someone power off wode during update process (The firmware will be damaged)to sloppy quality control. In both cases only the "special" programmer can be used to recover the main board.
WODE DFU PROGRAMMING BOARD + DEBUG SERIAL BOARD
With this new board we have in one device:
1- DFU programming board unbrick wodes.
2- SERIAL USB board that allows to communication with the DEBUG PORT on the back of WODE (a 32 pin connector should be installed on the back of WODE and you should have OPEN WODE FIRMWARE installed)
Good tool not only to unbrick wode, but also good for development
HOW TO SETUP NEW "WODE PROGRAMMER + DEBUG BOARD" for DFU UNBRICK PROGRAMMING 1- You should close the jumpers like this order JP1: pin 2-3 JP2: pin 1-2 JP3: pin 2-3 2- Connect the 32 pin connector on the back (DFU PORT) to SLAVE connector on WODE 3- Connect the USB CABLE to DFU USB port 4- Follow the instructions of previus WODE programmer